Unmanned Aircraft Systems

AIM ¶ 7-6-6 Unmanned Aircraft Systems

AIM 7-6-6 explains UAS operations in the NAS: COAs, NOTAMs, see-and-avoid, and pilot vigilance tips for student pilots prepping for checkride.

In Plain English

Unmanned Aircraft Systems (UAS) — drones flown by a remote pilot and crew — are increasingly sharing the National Airspace System (NAS) with manned aircraft. Unlike model aircraft (typically below 400 ft AGL), UAS can operate at virtually any altitude and speed, in sizes from a few pounds to airliner-scale, and across categories like airplane, rotorcraft, powered-lift, and lighter-than-air.

Military UAS usually fly inside restricted or special use airspace. Outside that, civil UAS need either a Certificate of Waiver or Authorization (COA) or a special airworthiness certificate. Key points:

  • Operations are confined to specific lateral boundaries and altitudes.
  • A NOTAM is typically issued — always check NOTAMs along your route.
  • Observers provide see-and-avoid for compliance with 14 CFR 91.113.
  • At or above FL180, UAS operate under IFR like manned aircraft.
  • Small UAS may operate in Class G over military property up to 1,200 ft AGL without special authorization (NOTAM still required); these areas may not be charted.

Why it matters: UAS are often small and hard to see, and you can't assume the remote crew sees you. Monitor CTAF near uncontrolled fields, stay vigilant near military installations and SUA, and be ready for evasive action.

AIM Source Text
FAA AIM ¶ 7-6-6
7-6-6. 7-6-6. Unmanned Aircraft Systems Unmanned Aircraft Systems (UAS), formerly referred to as “Unmanned Aerial Vehicles” (UAVs) or “drones,” are having an increasing operational presence in the NAS. Once the exclusive domain of the military, UAS are now being operated by various entities. Although these aircraft are “unmanned,” UAS are flown by a remotely located pilot and crew. Physical and performance characteristics of unmanned aircraft (UA) vary greatly and unlike model aircraft that typically operate lower than 400 feet AGL, UA may be found operating at virtually any altitude and any speed. Sizes of UA can be as small as several pounds to as large as a commercial transport aircraft. UAS come in various categories including airplane, rotorcraft, powered-lift (tilt-rotor), and lighter-than-air. Propulsion systems of UAS include a broad range of alternatives from piston powered and turbojet engines to battery and solar-powered electric motors. To ensure segregation of UAS operations from other aircraft, the military typically conducts UAS operations within restricted or other special use airspace. However, UAS operations are now being approved in the NAS outside of special use airspace through the use of FAA-issued Certificates of Waiver or Authorization (COA) or through the issuance of a special airworthiness certificate. COA and special airworthiness approvals authorize UAS flight operations to be contained within specific geographic boundaries and altitudes, usually require coordination with an ATC facility, and typically require the issuance of a NOTAM describing the operation to be conducted. UAS approvals also require observers to provide “see-and-avoid” capability to the UAS crew and to provide the necessary compliance with 14 CFR section 91.113. For UAS operations approved at or above FL180, UAS operate under the same requirements as that of manned aircraft (i.e., flights are operated under instrument flight rules, are in communication with ATC, and are appropriately equipped). UAS operations may be approved at either controlled or uncontrolled airports and are typically disseminated by NOTAM. In all cases, approved UAS operations must comply with all applicable regulations and/or special provisions specified in the COA or in the operating limitations of the special airworthiness certificate. At uncontrolled airports, UAS operations are advised to operate well clear of all known manned aircraft operations. Pilots of manned aircraft are advised to follow normal operating procedures and are urged to monitor the CTAF for any potential UAS activity. At controlled airports, local ATC procedures may be in place to handle UAS operations and should not require any special procedures from manned aircraft entering or departing the traffic pattern or operating in the vicinity of the airport. In addition to approved UAS operations described above, a recently approved agreement between the FAA and the Department of Defense authorizes small UAS operations wholly contained within Class G airspace, and in no instance, greater than 1200 feet AGL over military owned or leased property. These operations do not require any special authorization as long as the UA remains within the lateral boundaries of the military installation as well as other provisions including the issuance of a NOTAM. Unlike special use airspace, these areas may not be depicted on an aeronautical chart. There are several factors a pilot should consider regarding UAS activity in an effort to reduce potential flight hazards. Pilots are urged to exercise increased vigilance when operating in the vicinity of restricted or other special use airspace, military operations areas, and any military installation. Areas with a preponderance of UAS activity are typically noted on sectional charts advising pilots of this activity. Since the size of a UA can be very small, they may be difficult to see and track. If a UA is encountered during flight, as with manned aircraft, never assume that the pilot or crew of the UAS can see you, maintain increased vigilance with the UA and always be prepared for evasive action if necessary. Always check NOTAMs for potential UAS activity along the intended route of flight and exercise increased vigilance in areas specified in the NOTAM.
Oral Exam Questions a DPE Might Ask
Q1What authorizations allow civil UAS to operate in the NAS outside special use airspace?
Per AIM 7-6-6, civil UAS may operate in the NAS through an FAA-issued Certificate of Waiver or Authorization (COA) or a special airworthiness certificate, which define geographic boundaries, altitudes, ATC coordination, and typically require a NOTAM.
Q2How are UAS operations handled at or above FL180?
Per AIM 7-6-6, at or above FL180 UAS operate under the same requirements as manned aircraft — under IFR, in communication with ATC, and appropriately equipped.
Q3As a manned-aircraft pilot, what should you do to mitigate UAS-related hazards?
Per AIM 7-6-6, check NOTAMs for UAS activity along your route, exercise increased vigilance near restricted/special use airspace, MOAs, and military installations, monitor the CTAF at uncontrolled airports, never assume the UAS crew sees you, and be prepared for evasive action.
Related Paragraphs in AIM Chapter 7
Master the AIM
Stop guessing. Drill it.

Adaptive questions tied to the live AIM + FAR. Mock checkrides predict your DPE pass rate.

5 questions/day free • No credit card
AIM 7-6-6 — Unmanned Aircraft Systems (UAS)